Sauder 403932 Instructions De Montage page 23

Step 19
With someone's help, carefully turn your unit over onto its front
å
edges. Unfold the BACK (P2) and lay it over the center of your unit.
Make equal margins along all four edges of the BACKS (P2). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (P2) to your unit using fi fty-three NAILS (BBB).
å
Lay the BACKS (O2) over the outside of your unit.
å
Make equal margins along three edges of the BACKS (O2). Push
å
on opposite corners of your unit if needed to make it "square".
The BACKS (O2) will overlap the center BACK (P2).
Fasten the BACKS (O2) to your unit using the remaining NAILS (BBB).
å
NOTE: Be sure to tap NAILS into the holes that line up over the
å
UPRIGHTS (E, F, G, and H), TOPS (J and K), and SHELF (L).
NOTE: Perforations have been provided for access through the
å
LARGE BACK. Carefully cut out the holes needed.
Tap eight TACK GLIDES (QQ) into the ENDS (A and B) and
å
UPRIGHTS (F and G).
The BACKS (O2) will overlap
the CENTER BACK (P2).
A
F
QQ
www.sauder.com/services
O2
G
403932
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(126 used in this step)
These holes must line up over the
UPRIGHTS, TOPS and SHELF.
The BACKS (O2) will overlap
the CENTER BACK (P2).
P2
O2
B
For support, place packing
foam and magazines here.
BBB
NAIL
Page 23