Jj Silver 1/4" Machine Screw - Sauder August Hill Serie Instructions D'assemblage

Step 12
Carefully stand your unit upright.
å
Position your unit in its fi nal location. Turn the ADJUSTABLE FOOT (T) downward until it touches the fl oor.
å
IMPORTANT: The ADJUSTABLE FOOT should not extend beyond the bottom edges of the LEGS (I and J).
å
Fasten one of the DOORS (H) to the left END (A). Use the screws in the HINGES.
å
NOTE: You may need to loosen the mounting screw to slide it part way out of the slot. Retighten the screw before you
å
mount the HINGE to the END.
Fasten a PULL (X) to the DOOR (H). Use a WASHER (W) and a SILVER 1/4" MACHINE SCREW (JJ).
å
Peel a BUMPER from the BUMPER CARD (Y) and stick it on the DOOR where it comes in contact with the LOWER
å
UPRIGHT (C).
Repeat this step for the other door.
å
JJ
SILVER 1/4" MACHINE SCREW
(2 used in this step)
X
H
Y
Turn the ADJUSTABLE FOOT
downward until it touches the fl oor.
Page 16
J
A
W
Floor
T
C
410627
Mounting screw
J
I
www.sauder.com/services