Kohler K-14418 Guide D'installation page 5

2. Install the Showerhead
CAUTION: Risk of product damage. To avoid clogging the
showerhead spray outlets, use thread sealant tape on the
shower arm threads. Do not use thread sealant compound
(pipe dope).
Remove the temporary nipple from the shower elbow.
Apply thread sealant to the shower elbow, then install a 1/2"
NPT pipe nipple to the shower elbow. The nipple must extend
1-1/4" (3.2 cm) beyond the finished wall.
Turn the main water supply on.
Run hot and cold water through the shower arm to flush out dirt
and debris.
IMPORTANT! If a gasket is NOT installed on the escutcheon of
the shower arm: Apply a bead of plumbers putty or other sealant to
the back of the shower arm. Refer to the putty or sealant
manufacturer's instructions for proper application. This will ensure a
watertight seal.
Apply thread sealant tape to the pipe nipple and thread the
shower arm onto the pipe nipple.
Carefully tighten the shower arm to the pipe nipple with a clean
strap wrench.
Remove all excess putty around the escutcheon.
Kohler Co.
All manuals and user guides at all-guides.com
1/2"
Nipple
1-1/4"
(3.2 cm)
5 1031692-2-D