Risco LightSYS RP432KP Mode D'emploi page 3

Introduction
The user-friendly LightSYS LCD/LCD Proximity keypad enables simple operation and
programming of the LightSYS and ProSYS security systems.
The following instructions offer a brief keypad operation overview. For detailed
information on programming the system, refer to the LightSYS or ProSYS Installer and
User manuals.
Indicators
Power
Ready
Arm (Set)
Stay / Bypass
(Part Set/ Omit)
Tamper
Fire
LED (Red)
Arm / Alarm
On
Off
Slow Flash
Rapid Flash
On
Off
Slow Flash
On
Off
Slow Flash
Rapid Flash
On
Off
On
Off
On
Off
Flashing
Behaves in the same manner as the
System is operating properly from
AC power, its backup battery is in
good condition and there are no
troubles in the system.
No power.
System is in programming.
System trouble (fault).
System is ready to be armed.
System is not ready to be armed
System is ready to be armed (set)
while exit/entry zone is open.
System is armed in Full Arm or Stay
Arm (Part Set) mode.
System is disarmed (unset).
System is in Exit Delay.
Alarm condition.
System is in Stay Arm (Part Set) or
Zone Bypass (omit) mode.
No bypass zones in system.
Zone/keypad/external module has
been tampered.
All zones are operating normally.
Fire alarm.
Normal operation.
Fire circuit problem.
indicator.
3