Connecting The Power Supply - Husqvarna AUTOMOWER 310 Manuel D'utilisation

Si l'installation s'effectue dans une zone de travail avec
une forte pente, la station de charge doit être placée en
bas de la pente. Le robot tondeuse suit ainsi plus
facilement le câble guide jusqu'à la station de charge.
La station de charge ne doit pas être placée sur un îlot,
car ceci limiterait les possibilités de mise en place
optimale du câble guide. Si elle doit impérativement être
installée sur un îlot, le câble guide devra également être
connecté à l'îlot. Pour en savoir plus sur les îlots,
Limites à l'intérieur de la zone de travailà
rendez-vous à
la page17 .

3.3.2 Connecting the power supply

Take the following into consideration when planning
where to place the power supply:
• Close to the charging station
• Protection from rain
• Protection from direct sunlight
If the power supply is connected to an electrical socket
outdoors, this must be approved for outdoor use.
No parts of the power supply must be changed or
tampered with. For example the low voltage cable must
not be shortened or extended. Low voltage cables with 3
14 - Installation
m / 10 ft or 20 m / 66 ft length are available as optional
accessories.
It is possible to let the low voltage cable cross the
working area. The low voltage cable must be stapled
down or buried, and the cutting height should be such
that the blades on the blade disc can never come in
contact with the low voltage cable.
Make sure the low voltage cable is laid along the ground
and secured with pegs. The cable must lie close to the
ground so as not to be cut before the grass roots have
grown over it.
The low voltage cable must never be stored in a coil or
under the charging station s base plate as this can
interfere with the signals from the charging station.
The power supply must be placed where it is well
ventilated and is not exposed to direct sunlight. The
power supply must be placed under a roof.
It is recommended to use an earth fault-breaker when
connecting the power supply to the wall socket.
If the power supply cannot be plugged directly into a wall
socket, do not under any circumstances mount the
power supply at a height where there is a risk it can be
submerged in water (at least 30 cm / 12ʺ from the
473 - 001 - 02.11.2017