Connecting The Power Supply; Battery Safety; Installation - Husqvarna AUTOMOWER 430XH Manuel D'utilisation

away from the rotating blades. Never put
your hands and feet under the product.
• Never touch moving hazardous parts, such
as the blade disc, before it has come to a
complete stop.
• Never lift up the product or carry it around
when the main switch is in position 1.
• The product must never be allowed to
collide with persons or other living creatures.
If a person or other living creature comes in
the product's way it shall be stopped
immediately.
• Do not put anything on top of the product or
its charging station.
• Do not allow the product to be used with a
defective guard, blade disc or body. Neither
should it be used with defective blades,
screws, nuts or cables. Never connect a
damaged cable, or touch a damaged cable
before it is disconnected from the supply.
• Do not use the product if the main switch
does not work.
• Always switch off the product using the main
switch when the product is not in use. The
product can only start when the main switch
is set to 1 and the correct PIN code has
been entered.
• The product must never be used at the
same time as a sprinkler. Use the timer
function so the product and sprinkler never
run simultaneously.

3.1 Connecting the power supply

Take the following into consideration when
planning where to place the power supply:
• Close to the charging station
• Protection from rain
• Protection from direct sunlight
WARNING: The product is only to be
used with a power supply unit supplied
by Husqvarna.
The power supply must be placed where it is well
ventilated and must be placed under a roof. If the
power supply is connected to an electrical socket
outdoors, this must be approved for outdoor use.
It is recommended to use an earth fault-breaker
1039 - 001 - 18.01.2019
• Husqvarna does not guarantee full
compatibility between the product and other
types of wireless systems such as remote
controls, radio transmitters, hearing loops,
underground electric animal fencing or
similar.
• The built-in alarm is very loud. Be careful,
especially if the product is handled indoors.
• Metal objects in the ground (for example
reinforced concrete or anti-mole nets) can
result in a stoppage. The metal objects can
cause interference with the loop signal
which then can lead to a stoppage.
• Operation and storage temperature is 0-50
°C / 32-122 °F. Temperature range for
charging is 0-45 °C / 32-113 °F. Too high
temperatures might cause damage to the
product.

2.3 Battery safety

WARNING: Lithium-ion batteries can
explode or cause fire if disassembled,
short-circuited, exposed to water, fire,
or high temperatures. Handle carefully,
do not dismantle, open the battery or
use any type of electrical/mechanical
abuse. Avoid storage in direct sunlight.
For more information about the battery, refer to
Battery on page 14

3 Installation

(RCD) when connecting the power supply to the
wall socket.
WARNING: Applicable to USA/
Canada. If power supply is installed
outdoors: Risk of Electric Shock. Install
only to a covered Class A GFCI
receptacle (RCD) that has an
enclosure that is weatherproof with the
attachment plug cap inserted or
removed.
WARNING: No parts of the power
supply must be changed or tampered
with. The low voltage cable must not
be shortened or extended.
Installation - 9