Connecting The Power Supply; Battery Safety; Installation - Husqvarna AUTOMOWER 105 Manuel D'utilisation

• It is not permitted to modify the original design of
the product. All modifications are made at your
own risk.
• Check that there are no foreign objects such as
stones, branches, tools or toys on the lawn. If the
blades hit foreign objects the blades can be
damaged. Always switch off the product with the
main switch or ON/OFF button before clearing a
blockage. Inspect the product for damage before
staring the product again.
• If the product starts to vibrate abnormally. Always
switch off the product with the main switch or
ON/OFF button and inspect for damage before
staring the product again.
• Start the product according to the instructions.
When the product is enabled with the ON/OFF
button or when the main switch is set to
sure to keep your hands and feet away from the
rotating blades. Never put your hands and feet
under the product.
• Never touch moving hazardous parts, such as the
blade disc, before it has come to a complete stop.
• Never lift up the product or carry it around when it
is switched on.
• The product must never be allowed to collide with
persons or other living creatures. If a person or
other living creature comes in the product's way it
shall be stopped immediately.
• Do not put anything on top of the product or its
charging station.
• Do not allow the product to be used with a
defective guard, blade disc or body. Neither should
it be used with defective blades, screws, nuts or

3.1 Connecting the power supply

Take the following into consideration when planning
where to place the power supply:
• Close to the charging station
• Protection from rain
• Protection from direct sunlight
1418 - 007 - 17.09.2020
cables. Never connect a damaged cable, or touch
a damaged cable before it is disconnected from
the supply.
• Do not use the product if the main switch or the
ON/OFF button do not work.
• Always switch off the product using the main
switch or the ON/OFF button when the product is
not in use. The product can only start when the
main switch is set to
switched on and the indicator lamp is lit. The
correct PIN code must also be entered for the
product to start.
• The product must never be used at the same time
as a sprinkler. Use the
product and sprinkler never run simultaneously.
• Husqvarna does not guarantee full compatibility
between the product and other types of wireless
systems such as remote controls, radio
transmitters, hearing loops, underground electric
animal fencing or similar.
• The built-in alarm is very loud. Be careful,
especially if the product is handled indoors.
• Metal objects in the ground (for example reinforced
concrete or anti-mole nets) can result in a
stoppage. The metal objects can cause
interference with the loop signal which then can
lead to a stoppage.
• Operation and storage temperature is 0-50 °C /
32-122 °F. Temperature range for charging is 0-45
1 make
°C / 32-113 °F. Too high temperatures might cause
damage to the product.

2.3 Battery safety

WARNING:
explode or cause fire if disassembled, short-
circuited, exposed to water, fire, or high
temperatures. Handle carefully, do not
dismantle, open the battery or use any type
of electrical/mechanical abuse. Avoid
storage in direct sunlight.
For more information about the battery, refer to
on page 18

3 Installation

WARNING:
used with a power supply unit supplied by
Husqvarna.
When connecting the power supply, only use a wall
socket that is connected to an earth fault-breaker (RCD).
1 , or the ON/OFF button is
Schedule function so the
Lithium-ion batteries can
Battery
The product is only to be
Installation - 11