Connecting The Power Supply; Battery Safety; Installation - Husqvarna AUTOMOWER 430XH Manuel D'utilisation

• Start the product according to the
instructions. When the main switch is set
to 1; make sure to keep your hands and
feet away from the rotating blades. Never
put your hands and feet under the
product.
• Never touch moving hazardous parts,
such as the blade disc, before it has
come to a complete stop.
• Never lift up the product or carry it around
when the main switch is in position 1.
• The product must never be allowed to
collide with persons or other living
creatures. If a person or other living
creature comes in the product's way it
shall be stopped immediately.
• Do not put anything on top of the product
or its charging station.
• Do not allow the product to be used with a
defective guard, blade disc or body.
Neither should it be used with defective
blades, screws, nuts or cables. Never
connect a damaged cable, or touch a
damaged cable before it is disconnected
from the supply.
• Do not use the product if the main switch
does not work.
• Always switch off the product using the
main switch when the product is not in
use. The product can only start when the

3.1 Connecting the power supply

Take the following into consideration when
planning where to place the power supply:
• Close to the charging station
1352 - 001 - 09.12.2019
main switch is set to 1 and the correct PIN
code has been entered.
• The product must never be used at the
same time as a sprinkler. Use the
Schedule function so the product and
sprinkler never run simultaneously.
• Husqvarna does not guarantee full
compatibility between the product and
other types of wireless systems such as
remote controls, radio transmitters,
hearing loops, underground electric
animal fencing or similar.
• The built-in alarm is very loud. Be careful,
especially if the product is handled
indoors.
• Metal objects in the ground (for example
reinforced concrete or anti-mole nets) can
result in a stoppage. The metal objects
can cause interference with the loop
signal which then can lead to a stoppage.
• Operation and storage temperature is
0-50 °C / 32-122 °F. Temperature range
for charging is 0-45 °C / 32-113 °F. Too
high temperatures might cause damage
to the product.

2.3 Battery safety

WARNING:
can explode or cause fire if
disassembled, short-circuited,
exposed to water, fire, or high
temperatures. Handle carefully, do
not dismantle, open the battery or
use any type of electrical/
mechanical abuse. Avoid storage in
direct sunlight.
For more information about the battery, refer
Battery on page 15
to

3 Installation

• Protection from rain
• Protection from direct sunlight
Lithium-ion batteries
Installation - 9