Publicité
AC 2018BL
MULTI-BRAND COMPRESSION GAUGE PETROL-DIESEL/DCI
Important: please read these instructions carefully. Note the safe operational requirements.
Warnings and cautions. Use the product correctly and with care for the purpose for which it
is intended. Failure to do so may cause damage and/or personal injury and will invalidate the
warranty. Please keep instructions safe for future use.
WARNING! Ensure Health and Safety, local authority and general workshop practice regulations
are adhered to when using tools.
• DO NOT use tools if seals or threads are damaged. Any defective seal MUST be changed before
use, to avoid incorrect readings.
• Maintain tools in a good, clean condition for the best and safest performance.
• Ensure that a vehicle that has been jacked up, is adequately supported with axle stands.
• Wear approved eye protection.
• Wear suitable clothing to avoid snagging. DO NOT wear jewellery and tie back long hair.
• Ensure any disconnected fuel pipes are plugged to avoid spillage.
• Ensure that the correct connector is used for the engine being tested.
• Always release the pressure from the gauge, before disconnecting the quick release coupling.
• Account for all tools and parts being used and DO NOT leave them in or near the engine.
IMPORTANT: Always refer to the vehicle manufacturer's service instructions, or a proprietary
manual, to establish the current procedure and data.
INTRODUCTION
A comprehensive kit for testing the compression on both petrol and diesel vehicles.
Features 600psi gauge with large rubber bumper, straight and right angled quick connect fittings
and an extensive range of spark/glow plug and injector adaptors.
This kit will cover most modern car, van, truck, bus, agricultural and marine engines.
Supplied in tough carry-case.
SAFETY
Publicité
