Baby Lock BLDW-L2 Instructions

Sewing Accessories
Deluxe Walking Foot
with Three Soles
Instructions
The Baby Lock Deluxe Walking Foot is wonderful
for fabrics that stretch or slip easily, such as
velvet or corduroy. This foot has a set of feed
dogs that help feed multiple layers evenly without
shifting. This walking foot comes with three easily
interchangeable soles, a standard sewing sole,
open toe sole and a stitch-in-the-ditch sole. It also
comes with two exclusive 4.5" extension quilting
bars.
Baby Lock Exclusive Features:
• 1/4" cutout on the inside left and right toes of
each sole for stitching 1/4" away from a seam
or marking.
• Rubber feeding system that helps feed fabric evenly.
• Vertical marking on each sole 1/4" in front for
turning corners.
To Attach Walking Foot on the Machine:
Presser bar
1. Raise the needle and presser foot.
2. Remove the presser foot, presser foot holder and
presser foot holder screw.
3. Attach the walking foot to the presser bar by
inserting the fork onto the needle clamp pin.
4. Securely tighten the walking foot to the presser
bar with the presser foot holder screw.
Note:
For high shank machines attach the adapter
(included with machine) to the presser bar first to
extend the length of the presser bar before
attaching walking foot.
Baby Lock
(BLDW-L2)
Lever
Needle clamp
To Replace the Sole:
(Fig 1)
1. Loosen the screw three to five turns (Figure
#1) and slightly pull the sole holder out to
release the sole.
2. Align the holes of the replacement sole
so both sides are inserted in the holes,
two holes on the left and one on the right
(Figure #2).
3. Tighten the screw.
Helpful Hints:
• Use this foot when sewing only forward
feeding stitches.
• Operate the machine at low to medium
speed.
• To use the needle threader, lower the presser
foot and raise the needle to the highest
position.
(Fig 2)
Markings for turning