Cleaning & Maintenance - Össur REBOUND DUAL ST Notice D'utilisation

1. Remove strap from D ring.
2. Bend D ring mounted on the brace interior and push it inwards to
release from the keyhole lock. Remove from the rivet (Figure 10).
3. Attach D ring to the brace exterior by pushing down onto rivet
through the keyhole lock. Slide and click D ring into place. Place
keyhole lock with indented side facing up (Figure 11).
4. Replace strap. If needed, repeat steps for other D rings.
Range of Motion adjustment (ROM):
The brace has 0° extension stops attached to the hinges. If needed, range
of motion can be adjusted using the extension and flexion stop kits.
Extension and flexion stop kits are available separately for order.
To install a kit:
1. Remove the condyle pads from the medial and lateral hinges. Remove
retaining screws.
2. Using a short Philips head screwdriver, slide the 0° stop out of the
hinge on both sides.
3. Re-apply the desired extension stop and gently secure it with the
retaining screw.
4. Repeat steps to change the flexion stop.
NOTE: Do not overtighten retaining screw.
PCL Strap Attachment:
The PCL kit is designed to counteract posterior subluxation of the tibia.
Trim and adjust the PCL strap for proper fit.
To attach the PCL strap:
1. Take the end of the PCL strap with the alligator clip and loop it
through the PCL slot on the brace frame. Alligator clip will close on
the inside of the strap. Trim strap if necessary (Figure 12).
2. Loop the other end of the PCL strap through the frame. Fasten strap
and secure it onto the outside of the strap (Figure 13).
3. Place the adjustable pad in the middle of the strap. Trim the strap pad
if needed.
4. Fully extend the leg. Tighten the strap, securing the pad.
PRODUCT MATERIAL LIST
Aluminum, stainless steel, polycarbonate, polyamide, silicone,
thermoplastic elastomer, polyester, acetal, glass-filled nylon, low density
polyethylene, ethylene vinyl acetate, spandex, polyurethane, polyethylene.
CLEANING & MAINTENANCE
Follow the steps below to keep your brace in a good condition.
CLEANING
Liners, straps and pads can be removed for cleaning. Hand-wash using
mild non-detergent soap.
Rinse thoroughly
Air-dry
If the brace moves, clean lower liners and pads with an alcohol wipe or
damp cloth.
7