Beninca CP.RI624N Livret D'instructions page 14

Let us suppose it is necessary to:
- set an automatic closing time (TCA) of 100s
- activate pre-blinking
Perform the operations described below step by step:
Step Press Display
1
PAR
2
TCA
3
040
4
100
5
PRG
TCA
6
PAR
7
Log
8
TCA
9
Pre
10
OFF
11
12
PRG
Pre
13
PAR
In the event of malfunctions, by pressing key + or - the status of all inputs (limit switches, control and safety) can be displayed. One
segment of the display is linked to each input. In the event of failure it switches on according to the following scheme.
N.C. inputs are represented by the vertical segments. N.O. inputs are represented by the horizontal segments.
For example, with the leaves
completely closed the display
is as follows:
14
EXAMPLE OF PROGRAMMING
First menu
First function of the first menu
Value currently set for the function selected
Set the desired value with the <+> and <-> keys
The value is programmed
When programming has been made, the display goes to the function just set
Press <+> and <-> simultaneously to go to the higher menu
Second menu
First function of the second menu
Press <-> several times to select PRE logic
Value currently set for the function selected
Set the desired value with the <+> and <-> keys
ON
The value is programmed
When programming has been made, the display goes to the function just set
Press <+> and <-> simultaneously to go to the higher menu and quit programming or wait
30s.
����
����
the moment an Open impulse
is given:
Notes
DIAGNOSTICS
����
���� ����
���� ��� ���� �����
����
������
���
during the opening phase: with the leaves completely
open: