Attaching The Accessories; Filling The Water Reservoir; Turning On The Appliance - Kärcher SC 4.100 CB Instructions Abrégées

Operation
Illustrations on fold-out
page!

Attaching the Accessories

Open the cover of the appliance socket.
Tightly insert the steam plug into the ap-
pliance connector. The plug must click
into place audibly.
To disconnect: Press the cover of the
appliance connector down and discon-
nect the steam plug from the appliance
connector.
Illustration -
Connect the required accessories (see
Chapter "Using accessories) to the
steam gun. Insert the open end of the ac-
cessory on the steam gun and push onto
the steam gun until the unlocking button
of the steam gun locks into place.
Illustration
Use the extension pieces if necessary.
To do so, connect one or both exten-
sion pieces to the steam gun. Insert the
required accessories on the free end of
the extension piece.
Removing the Accessories
Danger
Hot water may drip out of the accessory
parts while you are detaching them! Never
detach accessory parts while steam
streams out - risk of scalding!
Move the selector switch for the steam
volume back (steam lever locked).
Illustration
To detach the accessory parts, press
the unlocking button and pull the items
apart.

Filling the Water Reservoir

The water reservoir may be refilled at any
time.
Caution
Do not use condensation water from the
drier!
Do not fill in detergents or other additives!
Illustration
You can remove the water reservoir to fill it
or you can fill it directly on the appliance.
18
Take off water reservoir.
Pull the water reservoir straight up.
Fill the water reservoir up to the "MAX"
marking while positioned vertically un-
der the water tap.
Insert the water reservoir and press
downwards until it arrests.
Directly on the appliance
Pour water from a container into the fun-
nel inlet. Fill up to the "MAX" marking.

Turning on the Appliance

Place the unit securely on a firm sur-
face.
Insert the mains plug into a socket.
Press the ON/OFFswitch to turn on the
appliance.
Indicator lamp "Heating on" is blinking
(green)
Note: If there is no or not enough water in
the steam boiler, the water pump starts and
supplies water from the reservoir into the
steam boiler. The filling process may take
several minutes.
Wait until the indicator lamp (heater)
lights up permanently.
The steam cleaner is ready to use.
Note: The appliance closes the valve every
60 seconds. This prevents the calcifying of
the appliance. There will be a slight audible
click. The steam delivery is not impaired by
this.
Refilling Water
In case of water shortage, the indicator
lamp "water shortage" glows red in the wa-
ter reservoir and a signal canb e heard.
Note:Every time there is not enough water
in the steam boiler, the pump automatically
supplies water from the water reservoir into
the steam boiler. If the water reservoir is
empty, the water pump is not able to fill the
steam boiler and the steam tapping is
blocked.
Fill the water reservoir up to the "MAX"
marking.
Note: The water pump tries to fill the steam
boiler in short intervals. If the filling is suc-
cessful, the steam tapping is release imme-
diately, and the red indicator lamp goes out.
– 8
EN