Fault Codes And Troubleshooting - Iseki SRE2600X Notice D'utilisation

GB
Malfunction
Rechargeable battery oper-
ating time is significantly
shorter.
Appliance vibrates or the
volume is too high.
Rechargeable battery can-
not be charged or low bat-
tery voltage
NOTE
For malfunctions that are not listed in this table or that you cannot resolve yourself, please con-
tact our customer service.

13.2 Fault codes and troubleshooting

Fault code
CN001: Tilt sensor
56
All manuals and user guides at all-guides.com
Cause
Cutting height level is too
low.
Grass is too long or too wet.
Imbalance on the cutting
blade or in the cutting blade
drive
■
The charging contacts of
the base station are dirty.
■
The contact surfaces on
the appliance are soiled.
■
Base station has no
power.
■
The appliance does not
touch the charging con-
tacts.
■
The contact surfaces on
the appliance are burned
out.
■
The fuse on the trans-
former is defective.
The service life of the re-
chargeable battery has ex-
pired.
The charging electronics are
faulty.
Cause
The inclination sensor has
been triggered:
■
Max. tilt exceeded
■
The appliance has been
carried
■
Slope too steep
Help in case of malfunction
Remedy
Increase the cutting height, then lower
in stages to the required height.
■
Let the grass dry.
■
Set the cutting height to a higher
level.
■
Clean the mower deck.
■
Contact a service centre of the man-
ufacturer.
■
Clean the charging contacts and
contact surfaces.
■
Connect the base station to the
power source.
■
Place the appliance in the base sta-
tion and check that the charging
contacts make contact.
■
Contact a service centre of the man-
ufacturer.
■
Change the fuse (see chapter 9.4
"Replacing the fuse on the trans-
former (11)", page 52).
■
Contact a service centre of the man-
ufacturer.
■
Contact a service centre of the man-
ufacturer.
Remedy
Place the appliance on a flat surface
and acknowledge fault.
SRE2600X