Publicité
Les langues disponibles
Les langues disponibles
NOTICE DE POSE PUSH CONTROL 2 POINT
BLOCAGE, BLOCAGE+ DOGGING ET DOGGING
INSTALLATION INSTUCTION PUSH CONTROL SERIES FOR 2 RIM POINT
BLOCKING, BLOCKING + DOGGING AND DOGGING
7
INSTALLATION OF THE TOP LATCH AND THE STRIKER (fig 6)
Use the lines drawn thanks to the D1 or D2 templates (chapter 1)
Position the screw partially the H8 screw
Attach the latch on the screw using the adjustment hole
Position and block the H9 screw
Block the H8 screw
Position and screw without blocking the striker with the H1 screws
(Using the thickness wedges if necessary)
A96 striker when the door and the frame are on the same plan (fig 7)
A93 striker when the door and the frame are on different plans (fig 8)
Check if the striker is correctly placed in comparison with the latch
Screw H2 and block the H1 screws.
8
INSTALLATION OF THE BOTTOM LATCH AND THE STRIKER (fig
9)
Use the line drawn thanks to the templates (chapter 1)
Position the screw partially the H8 screw
Attach the latch on the screw using the adjustment hole
Position and block the H9 screw
Block the H8 screw
Position and screw without blocking the striker with the H1 screws
Check if the striker is correctly placed in comparison with the latch
(fig 10)
Screw H2 and block the H1 screws.
9
INSTALLATION OF THE RODS (fig 11 and 12)
Cut the threaded rods (Fig 13)
Top rod : length X minus 10 mm
Bottom rod : length Y minus 10 mm
Screw the threaded rods in the connector latch driving plug
Screw the locknut on the other extremity of the threaded rods (fig
11)
Screw and adjust the driving end connectors in function of the main
case mechanism
Check if the 2 latches work correctly then block the locknuts
Immobilise the driving end connectors on the main case mechanism
with the rings.
10
CONFIGURATION DE POSE
NO1-705 Ind D
7 / 8
Publicité
