Hilti DD 150-U Mode D'emploi page 48

Bluetooth ON
Bluetooth OFF
Connection has been
established
Connection interrupted
Analysis of running time
Analysis of operating
behavior
Analysis of drilling direction
Analysis of gear selection
40 English
Bluetooth is activated in the basic setting.
To switch off the Bluetooth function, press and hold down the buttons
and simultaneously for 10 seconds with the motor switched off.
• This information is shown in the display only for a few seconds.
Bluetooth is deactivated. The diamond core drilling machine cannot be
connected to additional device or accessories.
To switch on the Bluetooth function, press the buttons
neously with the motor switched off.
• This information is shown in the display only for a few seconds.
The diamond core drilling machine is ready to connect to another device or
accessory.
To start the process of establishing the connection, simultaneously press
the and buttons and hold them down for at least 1 second.
• The time frame for the connection to another device is 2 minutes. When
the 2 minutes have expired, the connection process will be canceled.
The paired connection between another device or accessory and the
diamond core drilling machine is sustained until:
• The diamond core drilling machine is paired to a device or accessory of
the same type.
• Bluetooth is switched off.
An existing Bluetooth connected to a device or accessory has been inter-
rupted.
The display shows drilling time (diamond core drilling machine actually
drilling) at the top and operating hours (diamond core drilling machine
switched on) at the bottom. Both figures are shown in hours, minutes and
seconds.
To reset drilling time and all other analysis data, press the
hold it down for a few seconds.
• The information shown on the display disappears automatically after a
few seconds or when you press the
•
Pressing the again takes you to the next analysis data.
This display shows contact pressure during drilling time as a percentage
(%). This enables user behavior to be optimized.
• The information shown on the display disappears automatically after a
few seconds or when you press the
•
Pressing the again takes you to the next analysis data.
This display shows an evaluation of the drilling directions in %.
• The information shown on the display disappears automatically after a
few seconds or when you press the
•
Pressing the again takes you to the next analysis data.
This display shows an evaluation of the duration of use of the respective
gear in %. The arrow always points to the gear with the highest rate of use.
• The information shown on the display disappears automatically after a
few seconds or when you press the
•
Pressing the again takes you to the next analysis data.
and
button.
button.
button.
button.
2204400
*2204400*
simulta-
button and