How The Robot Works - Kokido Mangar RC32 Manuel D'utilisation

HOW THE ROBOT WORKS

The robot has a water-propelling nozzle at the bottom of the swivel head. Water is first
sucked in through the suction mouth at the bottom of the robot, which then goes through
the filter and is discharged via the propelling nozzle. Water jetting from the nozzle propels
the robot forward. Once the robot stops against an obstacle such as the pool wall, its side
flap sways and its swivel head turns 180
direction. The robot moves in a generally straight pattern in one direction and in an arc
pattern in the other direction. The robot vacuums the pool bottom as it moves, collecting
debris in its compartment.
1. Swivel head
Sliding switch
1.1.
Power indicating
1.2.
light
1.3. Water sensors
1.4. Charging port
Side flap (with
2.
side side pin)
Swivel
3.
smoothing-ring
4. Top cover
Swivel head
5. bottom screw
plate
6. Filter cover
7. Base
Yellow triangle
7.1.
pattern
Grip (under
7.2. Yellow triangle
pattern)
8. Locking pin
9. Wheel axle
Rear wheel (with
10.
washer)
Front wheel
11.
(with washer)
12. Bumper x 2
13. Clip-on rake
14. Clip-on brush
Draining filter
15.
plate
Drainage outlet
16.
flap
Suction mouth
17.
flap
Floor Squeegee
18.
x 4
19. Float
Hook (with
20. V-clip) for
Telescopic pole)
21. Charging cable
22. Adaptor
o
, allowing the robot to move in the opposite
Replacement Parts
Number
RC30ASM07
RC30ASM07/US (USA)
---------
---------
---------
---------
RC30-07
RC30-08-004
RC32ASM03
RC30-05-005
RC30-09
RC32ASM04
RC32ASM04/US (USA)
---------
---------
RC30-10-014
RC30ASM08
RC30-12
RC30-18
RC32ASM10
RC30ASM09
RC30-10-012
RC30ASM06
RC30-16
RC30-17-001
RC30-17-002 (EU)
RC30-17-002/US (USA)
RC30-17-002/AU
(Australia/New Zealand)
10