How The Robot Works - Kokido DELTA 100 Manuel D'utilisation

HOW THE ROBOT WORKS

The robot has a water-propelling nozzle at the bottom of the swivel head. Water is first
sucked in through the suction mouth at the bottom of the robot, which then goes through
the filter and is discharged via the propelling nozzle. Water jetting from the nozzle propels
the robot forward. Once the robot stops against an obstacle such as the pool wall, its side
flap sways and its swivel head turns 180
direction. The robot moves in a generally straight pattern in one direction and in an arc
pattern in the other direction. The robot vacuums the pool bottom as it moves, collecting
debris in its compartment.
1. Swivel head (with
side flap)
1.1. Sliding switch
1.2. Power indicating
light
1.3. Water sensors
1.4. Charging port
1.5. Protective cap
(for charging
port)
2. Side flap (with
side pin)
3. Swivel
smoothening-ring
4. Top cover
5. Swivel head
bottom screw
plate
6. Filter cover
7. Complete base
7.1. Grip (on swivel
head)
7.2. Grip (underneath
the base at wider
end)
7.3. Grip indicator
8. Locking pin
9. Rear wheel x 2
10. Small wheel x 2
11. Front wheel
12. Suction mouth
flap
13. Draining filter flap
x 2
14. Float
15. Hook (with V-clip)
for Telescopic
pole)
16. Charging cable
17. Adaptor
o , allowing the robot to move in the opposite
Replacement Parts
Number
Including float, swivel
smoothening-ring, protective
cap & bottom screw plate:
RC16ASM01
RC16ASM01/US (USA)
---------
---------
---------
---------
---------
RC16-07
RC35-08-004R
RC16ASM02
RC30-05-005/CP
RC16-09
RC16-10
RC16-10/US (USA)
---------
---------
---------
RC16-10-015
RC16ASM03
RC16ASM04
RC26-15
RC30-16/BLK
RC16-17-001
K96900163/EU (EU)
EV1000163/US (USA)
K96900163/AU
(Australia/New Zealand)
10