Working Advice; Maintenance And Cleaning - Würth BS 12-A MULTI Traduction Des Instructions De Service D'origine

OBJ_BUCH-3342-001.book Page 20 Thursday, December 14, 2017 9:18 AM
Battery Charge-control Indication
The battery charge-control indicator 8 consists of three green
LEDs, and indicates the charge condition of the battery for a
few seconds when the On/Off switch 7 is pressed halfway or
fully.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green

Working Advice

 Apply the power tool to the screw only when
it is switched off. Rotating tool inserts can slip off.
After longer periods of working at low speed, allow the
machine to cool down by running it for approx. 3 minutes at
maximum speed with no load.
For drilling in metal, use only perfectly sharpened HSS drill
bits (HSS=high-speed steel). The appropriate quality is guar-
anteed by the Würth accessories program.
Before screwing larger, longer screws into hard materials, it is
advisable to predrill a pilot hole with the core diameter of the
2
thread to approx. / of the screw length.
3

Maintenance and Cleaning

 Before any work on the machine itself (e. g.
maintenance, tool change, etc.) as well as dur-
ing transport and storage, remove the battery
from the power tool. There is danger of injury when
unintentionally actuating the On/Off switch.
 For safe and proper working, always keep the
machine and ventilation slots clean.
When the battery is no longer operative, please refer to an
authorised after-sales service agent for Würth power tools.
In all correspondence and spare parts orders, please always
include the article number given on the type plate of the
machine.
The current spare parts list for this power tool can be viewed
on the internet at http://www.wuerth.com/partsmanager or
be requested from your next Würth branch office.
For this Würth power tool, we provide a guarantee in accord-
ance with the legal/country-specific regulations from the date
of purchase (verified by invoice or delivery document). Dam-
age that has occurred will be corrected by replacement or
Capacity
repair.
Damage caused by normal wear, overloading or improper
≥ 2/3
handling is excluded from the guarantee.
≥1/3
Claims can only be accepted if the power tool is sent undisas-
< 1/3
sembled to a Würth branch office, your Würth sales repre-
sentative or a customer service agent for Würth power tools.
Reserve
The contained lithium-ion batteries are subject to the Danger-
ous Goods Legislation requirements. The user can transport
the batteries by road without further requirements.
When being transported by third parties (e.g.: air transport or
forwarding agency), special requirements on packaging and
labelling must be observed. For preparation of the item being
shipped, consulting an expert for hazardous material is
required.
Dispatch batteries only when the housing is undamaged.
Tape or mask off open contacts and pack up the battery in
such a manner that it cannot move around in the packaging.
Please also observe possibly more detailed national regula-
tions.
The machine, rechargeable batteries, accessories and
packaging should be sorted for environmental-friendly
recycling.
Do not dispose of power tools and batteries/
rechargeable batteries into household waste!
Only for EC countries:
According to the European Guideline 2012/19/EU, power
tools that are no longer usable, and according to the Euro-
pean Guideline 2006/66/EC, defective or used battery
packs/batteries, must be collected separately and disposed
of in an environmentally correct manner.
Battery packs/batteries:
Li-ion:
Please observe the instructions in section "Transport",
page 20.
Subject to change without notice.
Guarantee
Transport
Disposal
20