Additional Safety And Working Instructions - Würth BS 14-A LIGHT Traduction Des Instructions De Service D'origine

OBJ_BUCH-2226-001.book Page 12 Wednesday, July 9, 2014 1:50 PM
 Before any work on the machine itself (e. g.
maintenance, tool change, etc.) as well as dur-
ing transport and storage, remove the battery
from the power tool. There is danger of injury when
unintentionally actuating the On/Off switch.
 Do not open the battery. Danger of short-circuiting.
Protect the battery against heat, e. g.,
against continuous intense sunlight, fire,
water, and moisture. Danger of explosion.
 In case of damage and improper use of the
battery, vapours may be emitted. Ventilate
the area and seek medical help in case of com-
plaints. The vapours can irritate the respiratory system.
 Use the battery only in conjunction with your
Würth power tool. This measure alone protects the
battery against dangerous overload.
 Use only original Würth batteries with the volt-
age listed on the nameplate of your power
tool. When using other batteries, e. g. imitations, recon-
ditioned batteries or other brands, there is danger of injury
as well as property damage through exploding batteries.
 The battery can be damaged by pointed
objects such as nails or screwdrivers or by
force applied externally. An internal short circuit
can occur and the battery can burn, smoke, explode or
overheat.
Additional Safety and Working
Instructions
Dusts from materials such as lead-containing coat-
ings, some wood types, minerals and metal can
be harmful to one's health and cause allergic
reactions, lead to respiratory infections and/or
cancer. Materials containing asbestos may only be worked
by specialists.
• Provide for good ventilation of the working place.
• It is recommended to wear a P2 filter-class respirator.
Observe the relevant regulations in your country for the mate-
rials to be worked.
 Prevent dust accumulation at the workplace.
Dusts can easily ignite.
 Before any work on the machine (e. g., main-
tenance, tool change, etc.) as well as during
transport and storage, set the rotational direc-
tion switch to the centre position. Unintentional
actuation of the On/Off switch can lead to injuries.
 The battery is supplied partially charged. To
ensure full battery capacity, completely
charge the battery in the battery charger
before using for the first time.
 Read the operating instructions of the battery
charger.
 Apply the power tool to the screw only when
it is switched off. Rotating tool inserts can slip off.
 Adjust the gear switch only when the machine
is at a complete stop.
 If the gear switch cannot be pushed to the stop,
turn the drill chuck a little.
 To save energy, only switch the power tool on when using
it.
Symbols
The following symbols are important for reading and under-
standing the operating instructions. Please take note of the
symbols and their meaning. The correct interpretation of the
symbols will help you to use the machine in a better and safer
manner.
Symbol Meaning
BS 14-A LIGHT/BS 18-A LIGHT:
Cordless Drill Driver
Grey-marked area: Handle
(insulated gripping surface)
Article number
Read all safety warnings and all
instructions
Before any work on the machine
itself, remove the battery
Always wear ear protection.
Movement direction
12