Humminbird ICE HELIX Serie Guide D'installation

ICE HELIX® SERIES Installation Guide
Follow the instructions in this installation guide to install the ICE HELIX® shuttle and install the
control head and ICE transducer.
There may be some minor differences between the hardware described in this manual and the actual
hardware included, depending on the configuration you purchased. We encourage you to read this
guide completely so that you may understand the installation requirements.
Technical Support: If you find that any items are missing from your installation kit, visit our Web site
at humminbird.com or call Humminbird® Technical Support at 1-800-633-1468.
Supplies: In addition to the installation kit, you will need a Phillips screwdriver.
NOTE: The procedures and features described in this guide are subject to change without notice.
This guide was written in English and may have been translated to another language. Humminbird
is not responsible for incorrect translations or discrepancies between documents.
NOTE: The illustrations in this guide may not look the same as your product, but your unit will
function in the same way.
WARNING! Always make sure that conditions are safe before walking on the ice.
Installation Preparation
1
| Charging the Battery
The ICE HELIX fish finder comes with a NORSK lithium-ion battery and battery charger.
WARNING! Misusing the battery may cause a shortened life span or may present a risk of damage
to the device and/or bodily injury. Be sure to follow the safety rules listed below:
∆ Do not short circuit the positive (+) or negative (-) terminals with any metals.
∆ Do not reverse the positive (+) or negative (-) terminals.
∆ Do not heat, drop, disassemble, or crush.
∆ Do not expose to flame, spark or high temperature above 60C.
∆ Only use the included NORSK lithium-ion charger.
∆ Keep away from children.
WARNING! Power off all connected electronic devices when charging the battery.
NOTE: The ICE adapter kits do not include a battery or battery charger. Follow the manufacturer's
instructions for the battery you selected.
You should fully charge your battery before using it for the first time to ensure peak performance.
You should also check the charge on your battery at least once every 3 months. This is especially
important during periods of prolonged storage. This type of battery should not be stored in a
discharged state.
1. Remove the battery terminal covers.
2. Connect the red and black spade connectors on the charging cable onto the corresponding
battery terminals.
3. Connect the charging cable to the wall charger.
4. Plug in the wall charger to an outlet.
5. To see if the battery is fully charged, press the LED indicator on the battery once to display the
battery capacity, twice to display the voltage, and three times to turn off the LED indicator.
1
532821-2_A