Humminbird ICE HELIX Serie Guide D'installation page 5

ICE HELIX® SERIES Installation Guide
5. Open the battery viewing window and secure the back battery cover to the handle using the two
included #8 – 32 x 3/8" screws and #8 flat washers.
6. Attach the Velcro tabs on the inside of the front battery cover to the inside of the back battery
cover to secure it in place.
6
| Installing the Rod Holders
1. Align a rod holder with a threaded insert on the side of the handle.
2. Secure the rod holder to the handle using an included 1/4 - 20 x 5/8" screw. Hand-tighten only.
3. Repeat steps 1-2 with the second rod holder on the other side of the shuttle.
7
| Routing Cables and Connecting the Control Head
For HELIX 7 models, use the following instructions to route the cables:
1. Route all cables (power, transducer, accessories, Ethernet) through the cable pass-through
window to your control head.
2. Insert the cable connectors into the correct ports on the control head. Refer to the illustrations
Control Head Ports. The ports are labeled and the connectors are keyed to prevent incorrect
installation, so do not force the connector into the wrong port.
For HELIX 8, 9, and 10 models, use the following instructions to route the cables to the cable tray:
1. Route all cables (power, transducer, accessories, Ethernet) through the cable pass-through
window to your control head.
2. Use a Philips screwdriver to remove the screws from the bottom of the cable tray.
3. Hold the cable tray together and turn it over, so the Humminbird logo is facing up. Lift the
cover and set it aside.
4. See the illustration Locating the Cable Tray Slots. Insert each cable connector into the correct
slots in the tray.
Each slot is shaped specifically for each connector, and insertion should be easy. Route the
cables using the grooves in the tray.
CAUTION! It is important to place the connectors into the correct slots and right side up.
NOTE: If you are installing a MEGA 360 ICE in addition to the ICE transducer, you will route the
MEGA 360 ICE sonar cable to the control head and the ICE transducer will connect to the
MEGA 360 Y-cable. See the MEGA 360 ICE Installation Guide for more details.
5. Place the cover onto the tray. Hold the tray together and turn it over.
Attaching the Back Battery Cover
5
532821-2_A
Attaching the Rod Holders
Control Head Ports
COM (communications)
power transducer
COM (communications)
power transducer
NMEA 2000 Ethernet