Humminbird ICE HELIX Serie Guide D'installation page 6

ICE HELIX® SERIES Installation Guide
6. Install the screws in the holes on the bottom of the tray. Hand-tighten only. See the illustration
Removing the Screws to replace the screws.
7. Turn over the cable tray so the Humminbird log is facing up.
Confirm the cables hang straight, and untwist them if necessary.
8. Line up the slots on the cable tray with the matching ports on the back of the control head. Line
up the cable tray pins with the holes on the control head.
9. With the Humminbird logo facing up, plug the cable tray into the back of the control head. The
cable tray clasps should click into place. See the illustration Connecting the Cable Tray to the
Control Head.
10. Pull carefully on the cable tray to confirm the installation is secure.
11. Remove the cable tray (optional): Squeeze the sides of the cable tray until it releases.
Mount the control head
1. Place 1 rubber washer onto each gimbal knob.
2. Install the gimbal knobs (with washers) into each side of the control head. Tighten the knobs
just enough so you can slide the control head into the gimbal bracket arms.
3. Slide the control head into the bracket.
4. Adjust the control head viewing angle as needed, and tighten the gimbal knobs until the
assembly is secured. Hand-tighten only!
5. Pass any excess cabling back through the cable pass-through window and cinch the cover.
Connecting the Cable Tray to the Control Head
Assembling the Control Head and Bracket
532821-2_A
Removing the Screws
Turning over the Cable Tray
Locating the Cable Tray Slots
COM
(communications)
transducer
pin
Ethernet NMEA 2000
Inserting the Cable Connectors
into the Cable Tray
power connector
notch facing up
power
transducer
cable
groove
6
cover
power
pin