Publicité
Les langues disponibles
Les langues disponibles
NAPOLEON ZERO CLEARANCE FIREPLACE MODEL NZ25
INSTALLATION T O BE DONE BY A QUALIFIED INSTALLER and must be electrically connected and grounded in accordance with local
codes. In the absence of local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or the ANSI/NFP A 70-1990
1. Turn off any electrical power to the fireplace (if applicable). Open the lower louvred control
2. Locate the vibration reducing pad (one per fan) over the two threaded studs, piercing 2 holes into the pad. The fan must
be able to be positioned entirely onto the pad. If only one fan is used, install on the left hand side of the fireplace.
ONE F AN INSTALLATION:
3. Slide the fan to the back of the fireplace taking care not to damage the terminals. Position the fan onto the studs and
secure using the lock washers and wing nuts provided. Pull the leads to the front and right side of the ashpan housing.
4. Remove the junction box. Use a nut connector to attach the black wires of the variable speed switch and the power.
5. Pass the two fan leads and one thermodisc lead through the junction box bushing. The thermodisc is located inside the
outer shell, just above the louvre door. Connect one fan lead to the thermodisc lead and the other fan lead to the white wire of
the variable speed switch using nut connectors.
6. Thread the other thermodisc lead through the junction box bushing and connect to the white wire of the power cord using
a nut connector. Secure ground wire (green) to the threaded weld stud located on the junction box wall. Reposition the junction
box. Verify that the wires will not interfere with the fan.
TWO F AN INSTALLATION:
3. Slide the first fan to the back of the fireplace taking care not to damage the terminals. Position the fan onto the studs and
secure using the lock washers and wing nuts provided. Pull the leads to the front and right side of the ashpan housing.
4. Slide the second fan into place, position onto the studs and secure as before.
5. Remove the junction box. Use a nut connector to attach the black wires of the variable speed switch and the power.
6. Pass the four fan leads and one thermodisc lead through the junction box bushing. Connect one fan lead from each fan
and the thermodisc lead together and connect the other two fan leads to the white wire of the variable speed switch using nut
connectors.
7. Thread the other thermodisc lead through the junction box bushing and connect to the white wire of the power cord using
a nut connector. Secure ground wire (green) to the threaded weld stud located on the junction box wall. Reposition the junction
box. Verify that the wires will not interfere with the fan.
BECAUSE THE BLOWER IS THERMALLY ACTIVATED, WHEN TURNED ON, IT WILL AUTOMATICALLY START APPROXI-
MATELY 15-45 MINUTES AFTER LIGHTING THE FIREPLACE. USE OF THE FAN INCREASES THE OUTPUT OF HEAT.
NZ62 FAN KIT INSTALLATION INSTRUCTIONS FOR
NA TIONAL ELECTRICAL CODE in the United States.
This kit includes:
2
wing nuts
2
lock washers
1
vibration reducing pad
4
nut connectors
1
fan
/
bracket
C
W
WS-415-75 / 10.12.95
WS-450-09
WS-735-01
GA-GD-290.05
WS-175-10
EP-NZ-010.365
door.
Publicité
