KitchenAid KFID500ESS Instructions D'installation page 3

Product Dimensions
A*
F
35³⁄₄ ¹⁄₈
A. " ± " (90.8 cm
± 0.3 cm) cooktop height
(minimum) with leveling
legs screwed all the way in*
B. Model/serial/rating plates
(located behind the control
panel)**
*Range can be raised approximately 1" (2.5 cm) by adjusting
the leveling legs.
**Model/serial/rating plates may be rotated up from behind the
control panel for viewing from the front of the range.
***Excludes handle. Dimension given is from wall to front of oven
door and will vary based on electric outlet receptacle
installation.
B**
C*
D
E***
47³⁄₈ ¹⁄₈
C. " ± " (120.3 cm ± 0.3 cm)
overall height (minimum) with
leveling legs screwed all the way in*
28¹⁄₂ ¹⁄₄
D. " ± " (72.4 cm ± 0.6 cm)
depth with handle
¹⁄₈ ¹⁄₈
E. 26 " ± " (66.4 cm ± 0.3 cm)***
¹⁵⁄₁₆ ¹⁄₁₆
F. 29 " ± " (76.0 cm ± 0.2 cm)
width
Cabinet Dimensions
Cabinet opening dimensions shown are for 25" (63.5 cm)
countertop depth, 24" (61.0 cm) base cabinet depth and
36" (91.4 cm) countertop height.
IMPORTANT: If installing a range hood or microwave hood
combination above the range, follow the range hood or
microwave hood combination installation instructions for
dimensional clearances above the cooktop surface.
A freestanding range may be installed next to combustible walls
with zero clearance.
A
I
A. 18" (45.7 cm) upper cabinet to
countertop
B. 13" (33.0 cm) upper cabinet depth
C. 30" (76.2 cm) min. opening width
D. For minimum clearance to the top
of the cooktop, see NOTE.
E. U.S.A.: 30" (76.2 cm) min.
opening width
Proper positioning of outlet shown above.
*Nothing located in shaded areas can extend more than 1½"
(3.8 cm) from wall or range will not slide all the way back.
NOTE: 24" (61.0 cm) minimum when bottom of wood or metal
cabinet is covered by not less than ¹⁄₄" (0.64 cm) flame retardant
millboard covered with not less than No. 28 MSG sheet steel,
0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or
0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the cooking
platform and the bottom of an uncovered wood or metal cabinet.
B
D
C
E
J
G
F
H
K
F. Cabinet door or hinge should
not extend into cutout*.
G. 1½" (3.8 cm) min. from right
side cabinet
H. 2" (5.1 cm) min. from floor
I. 7" (17.8 cm) min. from floor
J. 8" (20.3 cm) width
K. 3½" (8.9 cm) min. from floor
3