Storing The Appliance; Frequently Asked Questions - Russell Hobbs RHEP6 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

and the exterior surface of the pressure cooker. NEVER immerse the pressure cooker in
any liquids.
Remove the Water collector (11) and rinse it thoroughly and let it dry. Clean the Upper
Body (8) with a damp sponge or wash cloth.
Clean the Lid (2) with warm soapy water, including the Sealing ring (18), Pressure
Limiting Valve (3), Filter (17), Vent, Floating Valve (4) and let them dry thoroughly.
The Pressure Limiting Valve (3) pops off easily by gently reaching underneath it and
gently pulling it upwards. Be careful not to damage the thin wire spring under it.
On the underside of the lid below the Pressure Limiting Valve (3), is a small metal filter
cap which can be removed easily to clean.
Wash the Inner Pot (6) with a non-abrasive sponge and allow to air dry or use a towel.
Clean the Pressure Limiting Valve (3) and the holes with a small brush to ensure smooth
flow of steam during the release cycle.
Let parts dry completely before reassembling.
To remove stubborn spots/marks, wipe the surfaces with a cloth slightly dampened in
soapy water or mild non-abrasive cleaner.

STORING THE APPLIANCE

Unplug the unit from the wall outlet and clean all the parts as instructed above. Ensure
that all parts are dry before storing.
Store the appliance in its box or in a clean, dry place.
Never store the appliance while it is still wet or dirty.
Never wrap the power cord around the appliance.

FREQUENTLY ASKED QUESTIONS

1. Is the Airtight/Exhaust Valve Knob on the top of the lid supposed to be loose?
- If you are not cooking or using the unit, the Valve Knob will be loose. It will turn 360
degrees and may even come off if you pull on it. Once you start using the pressure
cooker and the pressure has built up, and the Valve Knob is properly set to "Airtight" then
it will not be loose anymore.
- Sometimes during cooking and pressurizing, steam may escape from the Valve. It
indicates that the Valve is not seated properly/securely. Simply use tongs or a similar
utensil and gently/carefully adjust it so it is fitted properly.
19

Publicité

Table des Matières
loading

Table des Matières