Wall Mounting; Making A Call - Doro PhoneEasy Display 312C Mode D'emploi

All manuals and user guides at all-guides.com

Wall mounting

The telephone can be wall mounted by using the included wall mount
bracket. It can also be fitted to a standard wall plate without using screws
in Australia.
1. Secure two screws, vertically positioned 83 mm apart.
2. The screws should locate into the two keyholes on the back of the telephone.
3. Remove the hanging peg (located by the hook switch) by pushing it upwards.
4. Rotate the hanging peg 180 degrees, and then replace it.
The display
When the telephone is not in use the date and time, number of new and
total number of calls stored in the Caller ID memory will be shown in the
display.
The display will illuminate during ringing, when accessing memory
functions and dialling out.
Ringer signal
The ringer can be adjusted using the switches located on the side of the
telephone:
Ringer volume
e
Ringer melody
n

Making a call

Normal Dialling
1. Lift the handset.
2. Dial the desired telephone number.
Pre-Dialling
This allows you to enter and change a telephone number before it is dialled.
1. Enter the required telephone number. Mistakes can be erased by
pressing .
0
2. You can now either lift the handset, press
telephone number will now be dialled.
Please note!
During a conversation, you can switch from the handset to hands free mode at any time
by pressing . Press
s
English
again to terminate the call.
s
OR

, the displayed
s