Wall Mounting - Doro PhoneEasy 337ip Mode D'emploi

Wall mounting

The telephone can be wall mounted by using the
included wall mount bracket and two screws (not
included).
Warning!
Make sure that no cables, water pipes or gas
pipes are located inside the wall before drilling
into it.
1.
Drill two holes in the wall, vertically 3 mm apart.
2. Insert the screws, allowing them to project ~5 mm out
from the wall.
3.
Unplug and remove the handset.
4.
Fit the guide tabs (A) on the bracket into the slots (B)
on the back of the telephone, then slide the bracket
upwards until it snaps into place.
5.
Position the telephone so that the screws on the
wall fit into the slots in the bracket, then slide the
telephone downwards until it is hanging on the
screws.
6. Remove the handset hook (C) by pushing it upwards,
and insert it in the reversed position so that the small
tab (D) protrudes. The hook will now keep the handset
in the cradle when the phone is wall mounted.
B
A
English