Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Important!
Please note when programming all references to press = to press once and then
immediately release the button.
The earpiece of the handset may attract small ferromagnetic objects such as staples and pins,
care should be taken when placing the handset near these items.
Connection/Basic setting
1. Connect the curly cord to the handset and to the socket marked
on the side of the telephone.
2. Connect the mains adapter to the socket marked DC 9V on the back
of the telephone and then to an electrical wall socket.
3. The display should flash the word ENGLISH. If not press and hold
for approximately 4 seconds.
v
4. Select the desired language using
5. Select the desired contrast setting (2=normal) using
6. Set the hour (00-23) using
7. Set the minute using
8. Set the day using
9. Set the month using
10. Connect the telephone line cord to the socket marked
back of the telephone, and then to a network wall socket.
11. Lift the handset and listen for the dial tone.
Change the clock, language or contrast settings
If you wish to change the clock, language or contrast settings at a later date,
press and hold
v
Batteries
Four good quality AA alkaline batteries can be installed to protect the
memory during prolonged power failure. When the batteries are running
low
will be displayed.
1. Disconnect the telephone line cord.
2. On the underside of the telephone carefully remove the battery cover.
3. Insert the backup batteries ensuring correct battery polarity is observed.
4. Replace the battery cover.
5. Reconnect the telephone line cord.
v
/
. Press
v
V
/
. Press
v
V
/
. Press
v
V
for approximately 4 seconds and repeat steps 4. - 9. above.
English
/
. Press
v
V
/
. Press
.
V
0
.
0
.
0
.
0
.
0
/
. Press
v
V
on the
T
q
.
0
Publicité
Table des Matières
