Connecting & Setting Up; Quick Overview - Samsung DVD-R135 Manuel D'instructions

Connecting &
Setting Up
This section involves various methods of
connecting the DVD Recorder to other external
components and setting required initial modes.

Quick Overview . . . . . . . . . . . . . . . . . . . . . . . . . . .14

Step 1 : Connecting the Antenna Cable . . . . . . . .15
Step 2 : Connecting the Video Cable . . . . . . . . . .18
Step 3 : Connecting the Audio Cable . . . . . . . . . .21
Step 4 : Connecting HDMI/ DVI to a TV . . . . . . . .24
Step 5 : Connecting External Devices . . . . . . . . . .26
Step 6 : Connecting the Power Cord . . . . . . . . . . .29
Step 7 : Preparing the Remote Control . . . . . . . . .29
14 - English
Quick Overview
A Quick Overview presented in this guide will give
you enough information to start using the recorder.
Step 1 : Connecting the Antenna Cable
†
Step 2 : Connecting the Video Cable
†
Step 3 : Connecting the Audio Cable
†
Step 4 : Connecting HDMI/ DVI to a TV
†
Step 5 : Connecting External Devices
†
Step 6 : Connecting the Power Cord
†
Step 7 : Preparing the Remote Control
•
Note to CATV system installer: : This reminder is
provided to call CATV system installer's attention to
Article 820-40 of the National Electrical Code
(Section 54 of Canadian Electrical Code, Part I),
that provides guidelines for proper grounding and,
in particular, specifies that the cable ground shall
be connected to the grounding system of the
building as close to the point of cable entry as
practical.