ACME CROSSWAVE Mode D'emploi page 24

Battery charger and how to charge
A high quality charger is included with the quadrocopter.
It helps you to charge and maintain the battery.
The following section shows you the details.
Only use original ACME LiPo-batteries.
!!! Third-party products can damage the model!!!
Make sure that there is sufficient air circulation and a dry and clean area while charging.
!!!Pay attention on the warning- and security notices!!! (Page 2)
Connect the power cable to the charger and then to your power outlet (100-240V).
Once the charger is ready for use, a red/green blinking will appear.
Connect the LiPo- batteries balancer cable (white plug) with the chargers front port.
Please note that it can only be plugged in one direction! The cable with the T-plug (black/red) are not required
for charging.
Charging starts automatically.
The three LEDs on the charger will light up in red.
Depending the batteries capacity, charging takes up to 1 till 1.5 hours. Each cell (3pcs) are being charged one
another.
As soon as one cell is fully charged, the matching LED switches to green, this may happen in various orders.
The battery is fully charged and ready for use as soon as all LEDs turn green. After you have carefully
disconnected the battery from the charger, the LEDs turn to standby mode again (Green/red flash).
NOTE:
If you disconnect the battery before charging is complete, the charger automatically switches to standby mode.
If the battery charger detects an overload or short circuit, charging stops automatically.
All manuals and user guides at all-guides.com
Never connect two batteries at once!
24
Technical details:
Input voltage: 100-240V AC
Output: 1200mA
Display: 3× Bicolor LED