Controller Features; Preparation - ACME CROSSWAVE Mode D'emploi

Controller features

The controller offers various possibilities to control and modify the zoopa CrossWave.
Left flip switch
Dual Rate
Left control stick
Trims left
On/Off button
Right flip switch
Flight mode
Right control stick
Trims right

Preparation

Only a few steps are required to get the zoopa CrossWave FPV Racer ready to fly.
Prepare sufficient space to work and get the content of the box ready.
You additionally require 4pcs. AA batteries 1.5V
---do not connect the flight battery yet--
Rotors
Prepare the 4 rotors. Their movement directions differ:
2 turning left (CCW)- and 2 turning right (CW).
Matching symbols are placed on the rotors (6x4,5 / 6x4,5R). In addition, 2 rotor nuts have different colors.
Silver nut >fixed turning right
Black nut >fixed turning left
!!The rotors have to be mounted tightly and in the correct way!!!
Perform this step for step. The caps need to be screwed against the rotational direction, fix them by using the
Allen key.
Assembly from pilot's view
Motor 1: front right – silver cap > orange rotor 6x4,5
Motor 2: front left – black cap > orange rotor 6x4,5R
Motor 3: rear left – silver cap > black rotor 6x4,5
Motor 4: rear right – black cap > black rotor 6x4,5R
All manuals and user guides at all-guides.com
1 (down) – Dual Rate activated > Beginner mode
0 (up) – 100% performance
Motor speed and vertical axis control
Adjustment of the flight attitude on the according axis
Middle- and end position will be indicated by a long beep-sound
Make sure that the trims are centered before flight
Switches the controller On and Off
Press for 2-3 seconds to activate
1 (down) – 3D mode (Flip; HeadLock)
0 (up) – Beginner mode (axis oversteering blocked)
Turn and Pan of the model
Adjustment of the flight attitude on the according axis
Middle- and end position will be indicated by a long beep-sound
Make sure that the trims are centered before flight
22