Wall Mounting - EUROM Sani Wi-Fi 400 Manuel De L'utilisateur

Assembly
The device is packed in one box. Remove all packaging material and check that the device is
not damaged. Do not use the device if it is damaged, but always contact your supplier. Keep
the packaging for safe storage and transport.

Wall mounting

WARNING
The wall used for mounting must be made from non-flammable material and
should be able to withstand a minimum temperature of 125 °C.
CAUTION
Make sure to use suitable fastening materials, depending on the surface.
Never block the space between the device and the wall.
1. Place the device on a non-flammable and
solid wall.
2. Place the device with a minimum distance
(Figure 8) of:
•
50 cm from the ceiling;
•
20 cm from the side walls;
•
10 cm from the floor;
•
50 cm clearance on the front side.
3. Do not mount the device:
•
immediately below a socket outlet;
•
on a ceiling or roof.
4. Place the wall bracket against the wall and
mark the five holes (Figure 9).
5. Drill five holes at the marked spots.
6. Place the plugs (Figure 9, pos. 3).
7. Screw and tighten the wall bracket (Figure 9,
pos. 1) to the wall with five large screws
(Figure 9, pos. 2) using a Phillips screwdriver
(Figure 9, pos.4).
22
Figure 8
Figure 9