Bras Is-Cream Carnet D'instructions page 19

considered of a general nature and may vary owing to the
applicable health and safety regulations in force.
2 Before disassembling the dispenser for washing, empty it of
all ice cream mixture. Proceed as follows:
1 on the keyboard, select the WASHING operating mode
2 if necessary wait for the mixture to liquefy
3 place a tub under the tap and empty all the contents of the
upper tank and cylinder
4 remove the cover.
If the cover is fitted with a safety lock, turn the key anti-
clockwise. (see figure 15)
5 fill the upper tank with water and allow the dispenser to ope-
rate in WASHING mode for a few minutes. Then empty out
the whole dispenser.
6 hold down key A to turn off the dispenser
7 turn off the main switch
7. 4. 1 DISASSEMBLY
ATTENTION
Before disassembling any component, always unplug
the appliance from the mains.
1 Remove the upper cover. (see figure 16)
If the cover is fitted with a safety lock, turn the key anti-
clockwise and remove it. (see figure 15)
figure 16
figure 15
2 If present, remove the upper basin mixer. (see figure 17)
3 Remove the mixing tube, both the upper part that the lower
part.
4 Remove the mixing tube and dismantle it (see figure 18)
and (see figure 19).
19
figure 17
figure 18
figure 19