Bras Is-Cream Carnet D'instructions page 18

EN GLIS H
I s - C r e a m
C Increase icon: to increase the value set.
D Confirm icon: to confirm the value set.
(see figure 11)
figure 11
CONSERVATION MODE
In this operating mode, the mixture in both the upper tank and in
the lower cylinder is kept at a suitable temperature to preserve
it. The display indicates the conservation icon. (see figure 12)
figure 12
When the mixture has reached the temperature set, the mixing
system slows down, the cooling system stops and the appliance
switches to wait mode. At default intervals (factory set to every
10 minutes), the mixing system increases the speed and the
cooling system is started to restore the proper temperature.
IMPORTANT
The product conservation temperature is factory set to
2°C.
WASHING MODE
In this operating mode, the cooling system is not in operation
and the mixing system turns at a speed suitable for washing the
machine. The display indicates the Washing icon. (see figure
13)
figure 13
ALARMS
The machine is fitted with a self-diagnosis system. In the event
of a breakdown, the user is notified by the alarm icon on the
display. Press this icon to display the explanatory text relating to
the alarm under way. (see figure 14)
MAINTENANCE ALARM (AL14)
Every 1500 hours of operation is necessary to replace the seal
placed in the wiper terminal. Carried out such a replacement is
necessary proceed with the reset alarm AL14.
To reset the alarm 14 is necessary:
- press parameters icon
- type user password (0000)
- press on hourglass icon
- press RESET button
- type user password (0000)
- press exit button
7. 2 OPERATION HELPFUL HINTS
The appliance parameters are factory set to guarantee optimum
operation. They must only be changed by the manufacturer, by
his technical support team or other similarly qualified persons, in
order to prevent any risks of malfunctioning.
7. 3 SUGGESTIONS
1 Every dispenser like this one needs to generate heat.
Should the heat generated be excessive, make sure that no
heat sources are situated in the vicinity of the dispenser and,
specifically, near the gridded panels. Also make sure the air
flow is not obstructed by the closeness of walls, boxes or other
items. Leave a clearance of at least 15 cm all around the
dispenser. Also make sure the filter situated beneath the rear
panel is clean.
2 This appliance is only intended for use with confectionery
products.
ATTENTION
Appliance usage is restricted to persons having safety/
hygiene knowledge and practical experience with the
appliance.
7. 4 CLEANING
1 Cleaning and washing the appliance are vital to guarantee
perfect preservation of product flavour and maximum efficiency
of your dispenser. The procedures described below must be
18
figure 14