Installing Your Microwave Oven; Setting The Time - Samsung MG402MADXBB Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTALLING YOUR MICROWAVE OVEN

Place the oven on a flat level surface 85cm above the floor. The surface
should be strong enough to safety bear the weight of the oven.
1. When you install your oven, make sure there is
adequate ventilation for your oven by leaving at least
10 cm (4 inches) of space behind and, on the sides
of the oven and 20 cm (8 inches) of space above.
2. Remove all packing materials inside the oven.
Install the roller ring and turntable.
Check that the turntable rotates freely.
3. This microwave oven has to be positioned so that plug is accessible.
If the supply cord is damaged, it must be replaced by a special cord
or assembly available from the manufacturer or its service agent. For
your personal safety, plug the cable into a 3-pin, 230 Volt, 50 Hz, AC
earthed socket. If the power cable of this appliance is damaged, it must
be replaced by a special cable.
Do not install the microwave oven in hot or damp surroundings like
next to a traditional oven or radiator. The power supply specifications
of the oven must be respected and any extension cable used must
be of the same standard as the power cable supplied with the oven.
Wipe the interior and the door seal with a damp cloth before using your
microwave oven for the first time.
MG402MADXBB_SG_DE68-04085C-05_EN.indd 9

SETTING THE TIME

Your microwave oven has an inbuilt clock. When power is supplied, ":0",
"88:88" or "12:00" is automatically displayed on the display.
Please set the current time. The time can be displayed in either the 24- hour
20 cm
10 cm
above
behind
or 12-hour notation. You must set the clock:
• When you first install your microwave oven
• After a power failure
85 cm of
10 cm on
the floor
the side
Do not forget to reset the clock when you switch to and from summer
and winter time.
Auto energy saving function
If you do not select any function when appliance is in the middle of
setting or operating with temporary stop condition, function is canceled
and clock will be displayed after 25 minutes.
Oven Lamp will be turned off after 5 minutes with door open condition.
1. To display the time in the...
24-hour notation
12-hour notation
Then press the Clock ( ) button once or twice.
2. Set the hour with the h button and the minutes with
the min button.
3. When the right time is displayed, press the Clock
button again to start the clock.
Result :
9
The time is displayed whenever you are
not using the microwave oven.
2015-12-07
12:22:43

Publicité

Table des Matières
loading

Table des Matières