Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Einbauanl_CD5_0.book Seite 41 Montag, 1. Juli 2002 2:38 14
Changing the calibration (
Deleting the calibration:
If the navigation system is removed from one vehicle and installed in
another, it must be calibrated. However, to do so, the current calibration
data must be deleted.
In the Service Mode, select
and press to confirm.
Using the SELECT control select
calibration is deleted and the unit returns to the Service Mode.
Calibration setting:
Calibration settings should only be made when the val-
ues to be entered are known. The unit cannot perform
correct route calculations if incorrect values are en-
tered.
It is possible to provide calibration settings.
In the Service Mode, select
and press to confirm.
Using theSELECT control select
Unit rotation can be selected in degrees by turning the SELECT control
and pressing to confirm.
Subject to correction and technical modifications
)
CALIBRATION
using the SELECT control
CALIBRATION
and press to confirm. The
DELETE
using the SELECT control
CALIBRATION
and press to confirm.
MODIFY
41
Installation guide
GPS INFO
C A L I B R A T I O N
CALIBRATION RIDE
DO NOT DELETE
D E L E T E
MODIFY
GPS INFO
C A L I B R A T I O N
CALIBRATION RIDE
DELETE
M O D I F Y
DO NOT DELETE
HORIZONTAL UNIT ROTATION
0
Copyright by Becker GmbH, D-76303 Karlsbad
Publicité
Table des Matières
