Cleaning The Machine - Bodum 11754 BISTRO Mode D'emploi

Switching Off The Programmable Coffee Maker
Using the safety switch (17) it is possible to switch the
Programmable Coffee Maker off at any time.
Prior To Using The Programmable Coffee Maker
Clean the appliance prior to first use. In order to do so fill the
water tank (2) with water to the MAX line and allow the appli-
ance to run with the filter holder (6), coffee filter (7) and glass
jug (9) in place but without ground coffee. Afterwards simply
tip the water away. Wait at least 10 minutes before starting
to use the appliance regularly.
HOW TO USE THE Open the lid (3) and fill the tank with the desired volume of
PROGRAMMABLE
cold water. However, do not fill beyond the MAX and below
COFFEE MAKER
the MIN line on the water tank window (10). Close the lid (3).
Note: If the water tank (2) is empty appliance will not switch
on for safety reasons, in order to prevent the heating element
from running whilst dry.
WARNING: Only top up the water tank (2) with cold, clear
water. Do not add any milk or other liquids to the water tank.
To make a pot of coffee fill the coffee filter (7) with a max-
imum 12 level BODUM® measuring spoons,of filter ground
coffee . When making a smaller quantity of coffee you will
require proportionally less ground coffee.
CAUTION: Only use the coffee filter (7) supplied with the
appliance. Never use paper filters.
Press the Stand by button (15) once to start the brewing pro-
cess. The rim of the Stand by button will begin to illuminate
white.
After a few seconds the water starts to flow through the
shower into the filter holder (6) and subsequently into the
glass jug (9). This process requires approx. 10 minutes for a
jug of coffee.
Note: Do not open the lid (3) during the brewing process.
The appliance can get damaged.
After the brewing process, when the water tank (2) is empty.
The Programmable Coffee Maker will switch off and the heat-
ing plate (18) will turn on automatically.
9
Press the Stand by button (15) twice to turn off the appliance.
The white rim light will go out.
Note: You can take out the carafe, pour and serve coffee at
any time. The appliance will stop dripping automatically, but
return the carafe after latest 30 seconds.
AUTOMATIC To set the automatic start function, prepare the appliance for
START
the brewing process and then continue like this:
FUNCTION
1. Press the Stand by button (15) twice; the Program button
(12) rim will illuminate white.
2. Press Program button (12); the LCD will display a CLOCK.
Set the current time by pressing the HOUR (13) and MIN (14).
(See figure 3.)
Note: The time cycle is 24 hours; "AM" and "PM" will switch
once every 12 hours.
3. After setting the current time press Program button again,
the LCD will display TIMER, then set the automatic start time
by pressing the HOUR (13) and MIN (14). (See figure 4.)
At 8:15PM the program button rim light will be extinguished,
and the Stand by button rim light will be illuminated white.
The appliance will start automatically.
Note: If the coffee maker is left unattended for 30 minutes
after brewing, it will shut off automatically.
Figure 3
CLEANING THE When cleaning the Programmable Coffee Maker never use
MACHINE
any chemicals, steel wool or abrasive cleaners. Only clean
the body (1) with a damp cloth.
Never immerse the body in water. Remember that this is an
electrical appliance.
Note: Always disconnect the Programmable Coffee Maker
from the mains prior to cleaning the appliance.
Clean the Programmable Coffee Maker after every use. The
following parts are dishwasher safe (only in the top compart-
ment of the dishwasher):
Figure 4
10
EN