Menu Option: Power Settings - Paradigm soundplay Manuel Du Propriétaire

your soundbar's in-room sound, then computes
the required correction to yield optimal perfor-
mance within your acoustic environment.
Anthem Room Correction > Off or On: This
option turns the Anthem Room Correction
feature on or off. Activate by pressing the enter
button and the soundbar will respond with
'Saved'. Please note, turning ARC on and off
only makes a difference if ARC corrections have
not been loaded on the soundbar.

MENU OPTION: POWER SETTINGS

Power Settings: Enter the submenu by press-
ing the enter button. Here you may adjust the
soundbar's power options.
Power Settings > Power Standby: Enter the
submenu by pressing the enter button. Here
you choose whether the subwoofer is always on
or turns itself on and off automatically.
Power Settings > Power Standby > Auto
Standby (Default): This option configures the
soundbar to turn itself off after no audio signal
is detected for approximately 20 minutes. When
the soundbar detects an audio signal, it will
immediately turn itself on. Activate by pressing
the enter button and the soundbar will respond
with 'Saved'. Please note: When set to Auto
Standby, if the soundbar is manually turned off
(using the power button on the control panel or
remote control), the soundbar will not respond
to an incoming audio signal and will not turn on
automatically. In this situation, turn the sound-
bar on using the power button on the control
panel or remote control and the soundbar will
resume automatic power handling.
Power Settings > Power Standby > Always On:
This option configures the soundbar to remain on
23
Paradigm Soundplay Manual 101816.indd 23
at all times until it is manually turned off using
the power button on the control panel or remote
control. Activate by pressing the enter button and
the soundbar will respond with 'Saved'.
Power Settings > Power-On Volume: Enter the
submenu by pressing the enter button. Here
you can configure the default volume of the
soundbar when it powers on or comes out of
standby.
Power Settings > Power-On Volume > Set:
Enter the submenu by pressing the enter but-
ton. Here you choose set the power-on volume.
Power Settings > Power-On Volume > Set >
–90dB to +10dB: Using the up/down directional
buttons, choose the desired volume level. Once
set the soundbar will always be set to this level
when it powers on or comes out of standby. The
default level is –35dB.
Power Settings > Power-On Volume > Last
Used: When Power Standby is set to "Last
Used", the soundbar will power on or come out
of standby at a volume level matching the vol-
ume setting when it was powered off or went
into standby.
Power Settings > IP Control: Enter the submenu
by pressing the enter button. Here you can turn
IP Control off or on. IP Control allows the sound-
bar to respond to incoming IP commands from
networked home control systems connected via
Ethernet or Wi-Fi.
Power Settings > IP Control > Off or On: This
option turns the IP Control feature off or on.
Activate by pressing the enter button and the
soundbar will respond with 'Saved'.
Power Settings > Standby IP > Off or On: Enter the
submenu by pressing the enter button. Here you
2016-10-18 12:19 PM