Menu Option: Wireless Settings; Menu Option: Learn Remote - Paradigm soundplay Manuel Du Propriétaire

can turn Standby IP Control off or on. This allows
you to configure how the soundbar responds to
incoming IP commands when it is in standby mode.
Power Settings > Standby IP > Off or On: This
option turns the Standby IP Control feature off
or on. Activate by pressing the enter button and
the soundbar will respond with 'Saved'. When
this setting is set to "Off" the soundbar will not
respond to incoming IP command when it is pow-
ered off or in standby mode. If IP Control is set to
Off, Standby IP Control is disabled.

MENU OPTION: WIRELESS SETTINGS

Wireless Settings > Initialize Wi-Fi: Enter the
submenu by pressing the enter button. Here you
may setup a Wi-Fi connection, turn Wi-Fi on or
off, and reset Wi-Fi settings.
Wireless Settings > Bluetooth Pairing: Enter the
submenu by pressing the enter button. Here you
may setup a Bluetooth connection.

MENU OPTION: LEARN REMOTE

Please note: There may be remotes that the
soundbar cannot learn or that the soundbar
can not learn correctly. Due to the number of
available remotes, it is impossible to advise
which remotes will or will not work.
Please note: When learning from a second
remote, you will likely find it does not have but-
tons that directly correspond with all available
soundbar commands. Not all commands have
to be programmed. Some remotes offer 'func-
tion' buttons (F1, F2, etc.) that can be used to
program unique soundbar commands such as
'Bass Mode: Night' or 'Input: Optical 1'.
Please note: Some remote controls offer dis-
crete 'power on' and 'power off' buttons. Some
Paradigm Soundplay Manual 101816.indd 24
offer a single button to toggle power on and off.
The learning function of the soundbar allows
you to program either scenario.
Learn Remote: Enter the submenu by press-
ing the enter button. The settings in this menu
program the soundbar to respond to a second
remote control. The factory supplied remote
control will always work with the soundbar,
even if the soundbar is programmed to respond
to a second remote.
Using the up/down directional buttons, you can
select and program the following commands:
• Volume +
• Volume –
• Mute
• Next Input
• Previous Input
• Up
• Down
• Left
• Right
• Enter
• Bass Mode: Night
• Bass Mode: Normal
• Bass Mode: Bass+
• Stereo Mode: Wide
• Stereo Mode: Voice+
• Stereo Mode: Normal
• Power Toggle
• Power On
• Power Off
• Menu
• Input: Bluetooth
• Input: Optical 1
• Input: Optical 2
• Input: Analog 1
• Input: Analog 2
• ARC On [Anthem Room Correction On]
• ARC Off [Anthem Room Correction Off]
Choose the command you want to program
and press the enter button. The soundbar will
24
2016-10-18 12:19 PM