Paradigm soundplay Manuel Du Propriétaire page 10

3. Using a stud finder, determine if there is a wall
stud directly behind one of the three center
screw locations (fig. 2a). If no stud is found: use
the center most screw location and drill a pilot
hole for the wall anchor. Install a wall anchor
at this location. If a wall stud is found: drill a
pilot hole into the stud.
4. Using a screw, attach the wall bracket to the
wall. DO NOT tighten (fig. 2b).
5. Using a stud finder, determine if a wall stud
is directly behind any of the remaining screw
locations (fig. 2a).
If no stud is found: use the top and bottom
center-most screw locations. If a wall stud is
found: use the top and bottom screw locations
with a stud behind them.
Use a level to square the wall bracket and mark
the remaining pilot hole locations (fig. 2b).
6. Remove the wall bracket or pivot to access the
remaining screw locations (fig. 2b).
If no stud is found: drill pilot holes and install
wall anchors. If a wall stud is found: drill pilot
holes into the stud.
7. Using the screws, attach the wall bracket to
the wall. DO NOT fully tighten.
8. Use a level to square the wall bracket. Tighten
all screws (fig. 2b).
9. Attach audio and power cables as needed. Refer
to the 'Connection' section of this manual.
10. Move the soundbar into place and drop the
shoulder bolts into the wall bracket keyholes.
Before releasing, make sure the soundbar
has dropped fully into the keyholes and is held
firmly in place (fig. 3).
9
Paradigm Soundplay Manual 101816.indd 9
Fig. 2a
or
Fig. 2b
or
2016-10-18 12:19 PM