Protector AS-5030 Mode D'emploi page 16

AS-5030
| ENGLISH
DELETING individual or all TRANSMITTERS
Deleting individual TRANSMITTERS
1. Press the button (2) on the receiver for 2 seconds. The
LED „NETWORK" (3) begins to flash.
2. Activate the TRANSMITTER to be deleted by holding the
magnet once on the housing (6a) and removing it again
or pressing the Status button. The LED „NETWORK"
(3) stops flashing on the RECEIVER and the deletion is
completed.
Deleting all TRANSMITTERS
1. Press the button (2) on the receiver for 2 seconds. The
LED „NETWORK" (3) begins to flash.
2. Press the button (2) for 2 seconds again. The LED
„NETWORK" (3) stops flashing on the RECEIVER and the
deletion is completed for all TRANSMITTERS.
ASSEMBLY OF THE RECEIVER
Plug the receiver of the AS-5030.3 into a socket. Insert the
device to be connected into the socket of the receiver and
screw the replugging safety device (S) on. As soon as the
LED „NETWORK" (3) on the receiver lights up this is ready
for operation.
Note: The receiver should not be mounted behind a metal
panel, as the range can be restricted by this.
ATTENTION: Always check whether the power consumption
of the connected device is less than or equal to the switching
capacity.
ASSEMBLY OF THE WINDOW TRANSMITTER
Preparation
Mount the window transmitter (6) and magnet (8) on the
upper window frame and the window casement so that the
distance on all sides of the two housing parts is less than 7
mm. To adjust, use the enclosed washer parts for this (U).
1. Insert the battery with correct polarity into the window
transmitter (6) lower section. Note: Make sure that the
battery of the transmitter is placed on the metal tie bar
and do not slide it below this.
2. Determine the intended location for the window trans-
mitter and magnet and clean adhesive areas. Mount the
housing lower section of the window transmitter (6) at
the intended location with the enclosed double-sided
adhesive pad. Alternatively, a prepared hole is located
in the housing lower section, through which the window
transmitter can be screwed to the window frame. For
this, remove the board from the housing lower section
and screw the housing tight with the enclosed washer.
Replace the board after this.
3. Press the housing upper section of the window transmit-
ter onto the housing lower section.
4. Mount the housing lower section with the magnet (8) at
the intended location with the enclosed adhesive pad.
ATTENTION: The distance between the transmitter and
magnet must not exceed 7 mm and please ensure a firm
and correct fit of the individual components.
5. Insert magnet and close with the magnet housing upper
section (8).
16