What To Do In Case Of A Problem - Foster NFI 6830 Mode D'emploi

WHAT TO DO IN CASE OF A PROBLEM

The hob or the cooking zone doesn't start-up :
•
The hob could badly connected on the electrical network. Check the connection.
•
The protection fuse might have cut-off the power. Check the fuse.
•
The lock for the control might be activated. Unlock the control.
•
The touch control might be covered with grease or water. Clean the touch control.
•
An object is put on a key. Remove the object.
The control panel displays [ U ] :
•
There is no pan on the cooking zone.
•
The pan is not compatible with induction.
•
The bottom diameter of the pan is too small.
The control panel displays [ C ] or [ E ] :
•
Call the After-sales Service.
One or all cooking zone cut-off :
•
The safety system functioned.
•
You forgot to cut-off the cooking zone for a long time.
•
One or more sensitive keys are covered.
•
The pan is empty and its bottom overheated.
•
The hob also has an automatic reduction of power level and breaking Automatic overheating
Continuous ventilation after cutting off the hob :
•
This is not a failure, the fan continuous to protect the electronic device.
•
The fan cooling stops automatically.
The automatic cooking system doesn't start-up :
•
The cooking zone is still hot [ H ].
•
The highest power level is set [ 9 ].
The control panel displays [ L ] :
•
Refer to the chapter control panel locking page.
The control panel displays [ U ] :
• Refer to the chapter "Keep warm".
The control panel displays [ II ] :
• Refer to the chapter "Pause".
38