Use Of The Appliance; Ventilation; Starting-Up And Appliance Management; Before The First Use - Foster NFI 6830 Mode D'emploi

USE OF THE APPLIANCE

Wy wietlac
z
0 zero
ń...9
Power level
Wy wietlacz
U Pan detection
A Heat accelerator
E Error message
H Residual heat
P Booster*
L Locking
U Keep warm
II Pause

Ventilation

The cooling system is fully automatic. The cooling fan starts with a low speed when the calories
brought out by the electronic system reach a certain level. The ventilation starts his high speed
when the hob is intensively used. The cooling fan reduces his speed and stops automatically
when the electronic circuit is cooled enough.

STARTING-UP AND APPLIANCE MANAGEMENT

Before the first use

Clean your hob with a damp cloth, and then dry the surface thoroughly. Do not use detergent
which risks causing blue-tinted colour on the glass surface.

Induction principle

An induction coil is located under each heating zone. When it is engaged, it produces a variable
electromagnetic field which produces inductive currents in the ferromagnetic bottom plate of the
pan. The result is a heating-up of the pan located on the heating zone.
Of course the pan has to be adapted:
•
All ferromagnetic pans are recommended (you can verify it with a little magnet): cast iron
and steel pans, enamelled pans, stainless-steel pans with ferromagnetic bottoms...
• Excluded are: cupper, pure stainless-steel, aluminium, glass, wood, ceramic, stoneware,...
The induction heating zone adapts automatically to the size of the pan. With a pan with too small
a diameter the induction zone will not work. This diameter is varying in function of the heating
zone diameter.
If the pan is not adapted to the induction hob the display will show [ U ].
The heating zone is activated.
Selection of the cooking level.
No pan or inadequate pan.
Automatic cooking.
Electronic failure.
The heating zone is hot.
The boosted power is activated.
Control panel locking.
Maintain automatically of 7Ń°C.
The hob is in pause.
22