Samsung DVD-H1080 Manuel D'utilisation page 131

troubleshooting
Before requesting service, please check the following.
Problem
• Check the batteries in the remote control. They may need replacing.
No operations can be • Operate the remote control at a distance of no more than 20 feet.
performed with the • Remove batteries and hold down one or more buttons for several
remote control.
• Ensure that the disc is installed with the label side facing up.
Disc does not play.
• Check the region number of the DVD.
• 5.1 channel sound is reproduced only when the following conditions are
5.1 channel sound is
• Check whether the disc being played has the "5.1 ch" mark on the
not being reproduced.
• Check if your audio system is connected and working properly.
• In a SETUP Menu, is the Audio Output set to Bitstream?
• The features or action cannot be completed at this time because:
1. The DVD's software restricts it.
The
2. The DVD's software doesn't support the feature (e.g., angles).
icon appears on
3. The feature is not available at the moment.
screen.
4. You've requested a title or chapter number or search time that is out of
• Check if the disc has a Menu.
Disc Menu doesn't appear.
Play mode differs from
• Some of the functions selected in the Setup Menu may not work
the Setup Menu
selection.
The screen ratio
• The Screen Ratio is fixed on your DVDs.
cannot be changed.
No audio.
• Press the
The screen is blocked
• Press the
Forgot password
• Go to the contents and find the section of the instruction book that
If you experience other
problems.
• If the problem still cannot be solved, please contact your nearest
• Make sure that the disc is not dirty or scratched.
The picture is noisy or
distorted
• Clean the disc.
All manuals and user guides at all-guides.com
minutes to drain the microprocessor inside the remote control to reset
it. Reinstall batteries and try to operate the remote control again.
met :
1) The DVD player is connected with the proper Amplifier
2) The disc is recorded with 5.1 channel sound.
outside.
range.
properly if the disc is not encoded with the corresponding function.
• Make sure you have selected the correct Digital Output in the Audio
Options Menu.
button (on the front panel) for more than 5 seconds with
no disc inside. All settings will revert to the factory settings.
button (on the panel) for more than 5 seconds with no disc
inside. All settings including the password will revert to the factory
settings. Don't use this unless absolutely necessary.
contains the explanations regarding the current problem, and follow the
procedure once again.
Samsung authorized service center.
Action Page
P5
P8
P17-18
P50~51
P44~61
P52~53
P50~51
P19
P54
P4
English _3