Enlèvement Et Installation Du Cadre En Verre - Fireplace Xtrordinair 864 TV 40K Manuel Du Propriétaire

Enlèvement et installation du cadre en verre
Attention: L'appareil doit être complètement froid avant de retirer le verre.
Attention: Ne pas frapper ou claquer le verre.
Remarque: Retirez la barrière avant d'enlever la vitre (voir page précédente). Remplacer la barrière
après le remplacement du verre.
Based upon the face being used, either:
a
(a) swing the access door down and remove the top grill,
(b) remove the face (unscrew or lift off - see the instructions included with the face for details).
Open the six latches holding the glass frame in place (start with the bottom three) - follow the
directions shown to the right.
Lift the glass frame up and
b
pull it forward to remove.
Re-Attaching the Glass Frame:
a) Hang the glass frame on the firebox.
b) While holding in place, attach the upper latches
(follow the instructions above in reverse).
c) Lift the glass frame slightly and attach the lower latches.
NOTE: Make sure the glass frame is all the way in place - it should be flush with
the front of the fireplace when installed.
© Travis Industries
Maintenance
Latch
NOTE:
You may need to lift
Catch
the glass frame
(on glass frame)
while re-attaching.
5/22/2018
23
Top of
Firebox
Glass
100-01487