Plc Settings; Find A Parameter And Set Its Value - Nederman FlexPAK 800 DX Manuel D'instruction

EN FlexPAK 800/1000 DX
7

PLC settings

The following PLC displays show the different parameter settings that can be configured for
the unit.
7.1

Find a parameter and set its value

FlexPak
Hi Vacuum Unit
OFF
Time To Service
2000 hours
Set Parameter
Program Name
Do the following to find a parameter and set its value:
1. From the PLC status screen, press the down arrow
screen.
2.
Press 'Escape'
3.
Press the down arrow
4. Select 'Set Parameter'. Press 'OK'
5. Use the up or down arrows
6. Use the left and right arrows
7. Use the up or down arrows
8. Press 'Escape'
9. Press 'Escape
10. Press the up arrow
NOTE! There are several other input menus on the same level as the date and time screen.
If pressing the down arrow
to get to the date and time screen.
NOTE! The blinking cursor shows the current value that can be changed.
30
All manuals and user guides at all-guides.com
Thu 10:45
2018-02-01
ESC OK
H-Meter
SSR_Time
Cool_Tmr
ClenCyl
FItClean
DIRTime
ESC OK
to go to the main menu.
ESC
to go to 'Program'. Press 'OK'
OK
to find the parameter. Press 'OK'
to set the value. Press 'OK
to go to the main menu.
ESC
to go to go to the date and time screen.
ESC
to exit.
takes the PLC to one of those menus, use the left arrow
Stop
Program
Setup
Network
Diagnostics
ESC OK
> H-Meter
> MI =2000h:0m
> OT =0h:15m
> MN =1999h:45
> MN Ext =2000
Z
ESC OK
to go to the date and time
to confirm.
OK
to confirm.
to select a value.
>
>
>
>
>
ESC OK
1/1
ESC OK
to confirm.
OK
to confirm.
OK