Dometic 8000 Série Manuel D'utilisation page 15

28
➤ Position the toilet over the floor brackets
and tilt it up from the back .
➤ Push the discharge-assembly fitting and
hose into the discharge-loop outlet .
➤ Tighten the band clamp .
➤ Lower toilet back down to the floor .
➤ Turn on the water supply and electrical
power to the toilet .
➤ Check for leaks by pressing the flush
switch . If there is a leak, tighten the
connection .
30
Cover
Screw
Washer
8700 models only
➤ Drill pilot holes at the floor-mounting
holes .
➤ Install the screws and washers (provided)
using a 0 .375" (10 mm) socket wrench .
➤ Place the plastic covers over the screws .
15
Mounting Brackets
29
Mounting
Bracket
Screw
Washer
Cover
(Rear View)
8100, 8500, 8600, 8900 models
➤ Insert the plastic washers from the
floor-bracket kit into the fastener holes .
➤ Fasten the toilet to the brackets using
the short screws included with the
floor-bracket kit .
➤ Place the plastic covers over the
floor-bracket screws .
Toilets
EN