Dometic 8000 Série Manuel D'utilisation page 11

17
Hex-Head Screw
Floor Bracket
8100, 8500, 8600, 8900 models only
➤ Secure the floor brackets to the floor using
the long hex-head screws from the toilet
floor-bracket kit .
➤ Loosely tighten with a 0 .375" (10 mm)
socket wrench, using the mounting
bracket corner marks as guides .
I
Do not completely tighten the hex-
head screws to the floor . Brackets will
tighten when fastening the toilet to
the brackets .
19
Touchpad
Panel
➤ Route the touchpad or flush-switch Ethernet cable from the Ethernet connection on the
control module through the access hole on the wall .
➤ Secure the Ethernet cable to the touchpad or flush-switch panel .
➤ Snap the touchpad or flush-switch panel cover onto the panel bracket .
8700 models with flush handle only
➤ Route the 3-pin flush-handle cable from the control module to the toilet location .
➤ Route the Ethernet cable to the status panel location and secure the cable to the connection .
11
Control
Module
Touchpad
Cable
18
Flush-
Switch
Panel
8100 models only
➤ Turn the electrical power off .
➤ Route wiring from the circuit breaker or
fuse to the flush-switch panel location
using 12-gauge (or larger) tinned copper
wire .
➤ Route wiring from the flush switch to the
toilet location using 12-gauge (or larger)
tinned copper wire . Route the wiring
through the wiring access hole in the
floor .
➤ Fasten the wires to the appropriate leads
on the back of the flush-switch panel using
crimp-style wire connectors .
Flush
Switch
Toilets
(From Circuit
Breaker/Fuse)
(To
Toilet)
Control
Module
Flush Switch
Cable
EN