2. FUNCTION AND USE
2.1 Connecting
Connect the power supply under the bottom of the docking station and to a main electrical outlet. Place the
light in the dock and the battery will begin charging. This is indicated by a green light flashing.
2.2 Buttons
Indicator diode
Button B1 (large circle)
Button B2 (small circle)
2.3 Program modes
The Lumina Max LAD light can be used for multiply intended uses. Each type of treatment has its own program.
The set program is shown by the color of the indicator diode when the light is in program mode. Programs are
Green, Orange or Red program.
To enter program mode, press the two buttons on the same time and hold for 3s until a beep sounds. Scroll by
pressing either button and stop at the desired program, stop pressing the buttons and wait for the beep. The light
will stay in the chosen program until manually changed.
Light Curing – Green Program
The green program mode is used for curing composites and other dental materials.
1. Cure with the light (tip) as close to the composite as possible, as
light intensity is reduced by distance.
2. Build the restoration in multiply layers of 2-3mm composite and
cure each layer for 1s or 3s.
3. If each layer is wider that the tip – move the tip and cure again.
4. Always cure the final layer for 3s.
Caution
Never light directly on gingiva without a tip, as the heat may damage the tissue. If the com-
posite is darker than A3, use 3s for each layer as penetration of the light is reduced in darker
materials.
14
Button function: A1 = B1
Indicator diode
Button A1 (large circle)
Button A2 (small circle)
Button function: A2 = B2
SMALL BUTTON LARGE BUTTON
1s
3s